EAW QX Series Application Manual page 76

Passive Point Source
WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT – Lift the loudspeaker to align the
center threaded mounting hole with the brackets preferred mounting point.
• Using an Allen wrench, loosely thread the screws and washers (B, C & D) through
the bracket mounting point, through the selected rubber washer (E) and into the
loudspeaker's center threaded mounting hole. Repeat for the opposite side.
• Do to the bracket's slotted mounting point "A", the hardware may be preassembled
to the loudspeaker.
• Note: If using the slotted mounting point, the bracket must be installed oriented with
the slot angled upward, opposing the ground.
• Onto each of two button head screws (B), place a split-lock washer (C), a flat
washer (D) and the selected rubber washer (E). Thread these screws and related
hardware three complete turns into the loudspeaker's two threaded mounting
holes.
• Leave as large a space as possible between the rubber washer (E) and the flat
washer (D).
• WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT – Lift the loudspeaker
into the bracket slots with the large rubber washers (E) inside the bracket
and the flat and lock washers (C & D) outside the bracket.
• Position the loudspeaker to the desired angle.
• In securing the angle using the angle locking point, align the loudspeaker to desired
angle.
• Onto a socket head screw (F), place a lock washer (H) and a flat washer (G).
• Using an Allen wrench, loosely thread the screw and washers (F, G, & H) through
the bracket angle lock point and into the loudspeaker's center threaded
mounting hole.
• Using Allen wrenches, tighten all screws (B & F).
5. Review the MKC Series or MKD526 Loudspeaker installation
a. Confirm the loudspeaker is level or plumb depending on the configuration.
b. Confirm the aim angle is as expected.
c. Confirm all hardware is tight.
d. For weather protected applications, confirm all sealants were applied properly.
Application Guide
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
76