EAW QX Series Application Manual page 38

Passive Point Source
Output Tab
The Output Tab enables amplifier outputs to be
named and provides access to further sub-menus.
For all Output Tab menus, the amplifier output under
configuration is selected by highlighting one of
the output identifiers (1, 2, 3 or 4) at the top of the
display. The Output Tab also enables Speaker Preset
configurations to be created, exported, imported or
cleared.
Note:: The number of individual outputs available
for configuration will depend on the UXA Amplifier
amplifier model and the input, zone and output mode
configuration.
• The Routing menu (Diagram 4f) enables zones to
be assigned to amplifier outputs.
Note: Routing for zones specified as stereo will
automatically offer three output options: left channel,
right channel or summed mono. The summed mono
signal can potentially be used to drive a mono
subwoofer.
Diagram 4f
Application Guide
Diagram 4g
• The Delay menu (Diagram 4g) enables
delay to be applied to individual amplifier
outputs.
• The Equalizer menu (Diagram 4h) enables
parametric equalization to be applied to
individual amplifier outputs. Equalizer
settings configured for one amplifier output.
Diagram 4h
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
38