EAW QX Series Application Manual page 53

Passive Point Source
Model System in Resolution 2
NOTE: There are a variety of splay angles and pick point combinations that may be used
with the brackets. This will determined by the MKD models selected and coverage area
geometry. Data files for the brackets are available in Resolution 2 to allow for exact
configuration and angles that should be deployed.
Connect Cabinet Rigging Bracket to Bottom MKD1000
1. Position MKD1000 loudspeakers on side (using protective material to prevent any
cosmetic damage.
2. Remove screws from MKD cabinets as shown in Figure 1.
3. Line up holes on bottom speaker to rear cabinet rigging points, then select and
secure the angle suggested from Resolution 2 using supplied hardware screws (See
Figure 2)
Application Guide
Figure 1 - Remove screws from MKD1000 cabinets
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
53