Sundance Spas MARIN 880 Series Owner's Manual page 69

4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display. The water must be drained and replaced with fresh water.
Follow the instructions above to reset the timer. If you tap "snooze"
the message will clear but the error icon
reminder screen will reappear in 10 days. Refer to Section 13.3,
page 72, for filter location.
C. Programming the MicroClean® Outer Filter Timer
A programmable filter timer can be set to remind you when to clean or
replace the MicroClean Outer Filter. Tap
enter the Programming Menu.
1. From the "Water Care" Menu you can to set
the MicroClean Outer timer, Figure 12.6e.
2. Tap or
increments. The range is from OFF to 180
days. It is not recommended that this feature
be turned OFF. In order to continually
maintain clean and working filters, it should
be program as instructed.
Note: Pressing
The days will revert to the previous programmed setting. This feature
can be used to make corrections.
3. Tap to confirm and save your changes.
4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display. The filter must be cleaned or replaced. Follow the instructions
above to reset the timer. If you tap "snooze" the message will clear but
the error icon
10 days. Refer to Section 13.1, page 69, for cleaning instructions.
D. Programming the MicroClean® Inner Filter Timer
A programmable filter timer can be set to remind you when to replace the
MicroClean Inner Filter. Tap
Programming Menu.
1. From the "Water Care" Menu you can to set
the MicroClean Inner timer, Figure 12.6f.
2. Tap or
increments. The range is from OFF to 90
days. It is not recommended that this feature
be turned OFF. In order to continually
maintain clean and working filters, it should
be program as instructed.
Note: Pressing
made. The days will revert to the previous programmed setting. This
feature can be used to make corrections.
to change the days in 10-day
will clear any current changes made.
will display and the reminder screen will reappear in
MicroClean Inner
to change the days in 10-day
will clear any current changes
will display and the
(Figure 12.6b) to
MicroClean Outer 60
A
A
MicroClean Outer
60 Days Left
(Figure 12.6b) to enter the
50
A
A
50 Days Left
880 Series
60
days
Figure 12.6e
MicroClean Inner
50
days
Figure 12.6f
63