Sundance Spas MARIN 880 Series Owner's Manual page 25

Decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
Note: The "decontamination procedure" steps 9-15 should also be
used after the hot tub has been "Winterized" (Section 13.8) or has been
sitting without power for an extended period.
9. Add 2.5 ounces (71 g.) of sodium dichlor for every 100 gallons
(378 L.) of water. Refer to the table (below) for approximate water fill
capacity by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash,
and void the manufacturer warranty for your spa.
Water Fill Volume
Model
Altamar ...............................390 Gal (1,476 L) .............................10.0 oz
Aspen .................................563 Gal (2,131 L) .............................14.0 oz
Cambria ..............................335 Gal (1,268 L) ............................. 8.4 oz
Cameo ................................370 Gal (1,401 L) ............................. 9.0 oz
Capri ...................................230 Gal (871 L) ................................ 6.0 oz
Marin...................................320 Gal (1,211 L).............................. 8.0 oz
Optima ................................410 Gal (1,552 L) .............................10.25 oz
Maxxus ...............................570 Gal (2,158 L) .............................14.25 oz
*Use average fill volume for chemical maintenance
10. Leave hot tub cover open during this step to allow
excessive chemical vapors to exit hot tub, protecting
pillows and plastic knobs from chemical attack. If hot
tub is indoors, open doors and windows for proper
ventilation. Turn on all hot tub jets pumps for one hour, open all air
controls, turn on the blower, and place all massage selector knob(s)
in their center "combo" position as shown (right).
Note: You will need to press the jets pump button(s) and blower button
every 20 minutes since these functions have an automatic 20 minute
time-out function that turns them off.
Average
Fill Volume*
880 Series
Sodium
Dichlor
19