Important Additional Safety Instructions; Locating Your Sundance Hot Tub - Sundance Spas MARIN 880 Series Owner's Manual

Hide thumbs Also See for MARIN 880 Series:
Table of Contents

Advertisement

3.3

Important Additional Safety Instructions

When using this electrical equipment, basic safety precautions should
always be followed, including the following:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. A green colored terminal or a terminal marked G, Gr, Ground,
Grounding or the
or compartment. To reduce the risk of electric shock, this terminal
must be connected to the grounding means provided in the electric
supply service panel with a continuous copper wire equivalent in size
to the circuit conductors that supply this equipment (*IEC Publication
417, Symbol 5019).
3. At least two lugs marked "Bonding Lugs" are provided on the exter-
nal surface or on the inside of the supply terminal box/compartment.
To reduce the risk of electric shock, connect the local common bond-
ing grid in the area of the spa to these terminals with an insulated or
bare copper conductor not smaller than No. 6 AWG (10 mm²).
4. All field installed metal components such as rails, ladders, drains or
other similar hardware within 10 feet (3m) of the spa shall be bonded
to the equipment grounding buss with copper conductors not smaller
than No. 6 AWG (10 mm²).
5. SAVE THESE INSTRUCTIONS.
4.0

Locating Your Sundance Hot Tub

IMPORTANT: Because of the combined weight of the spa, water
and users, it is extremely important that the base upon which the
spa rests be smooth, flat, level and capable of uniformly support-
ing this weight, without shifting or settling, for the entire time the
spa is in place. Visit www.SundanceSpas.com for weight informa-
tion. If the spa is placed on a surface which does not meet these
requirements, damage to the skirt and/or the spa shell may result.
Damage caused by improper support is not covered under war-
ranty. It is the responsibility of the spa owner to assure the integrity
of the support over time. We recommend a poured, reinforced
concrete slab with a minimum thickness of 4 inches (10 cm). Wood
decking is also acceptable provided it is constructed so that it
meets the requirements outlined above.
WARNING:
!
roofs or other platforms not specifically tied into main
structural support, consult a professional Structural En-
gineer with experience in this type of application.
symbol* is located inside the supply terminal box
For spas that are to rest on balconies,
880 Series
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Capri 880 series

Table of Contents