Table of Contents
Advertisement
Maintenance
9.4 Inspection and maintenance
Figure 9-8
1. Release the four screws
2. Release the two screws
3. Remove the filter
4. Place a new filter in the frame
5. Reattach the frame of the filter and cover.
9.4.7
Maintaining the fan
Injury caused by rotating fan
If the drive is equipped with a temperature-controlled fan, the fan can run on even if the power
section is switched off. You can be injured if you touch the fan.
● Wait until the fan has shut down and has come to a stop.
148
Changing the filter in the roof assembly
③
.
If there is a slight amount of dirt, clean the filter mat at a suitable location. Depending on the
degree of pollution, you can also clean the filter mats using a vacuum cleaner. If the filter mat
is damaged, or the frequency of alarms increases, dispose of the dirty filter mat in the correct
fashion. Use a new filter mat
CAUTION
①
.
②
. Remove the filter frame.
④
.
Operating Instructions Rev.201910281345 EXAMPLE
SINAMICS SM150 6SL3845-7NN46-7AA2
Advertisement
Table of Contents
