CAUTION:
Do not force the 4-port card into place. If the 4-port card does not smoothly seat, realign the pegs
and try again.
Figure 21. Seating the 4-port card
3. Gently push down on the upper-left circle on the 4-port card.
4. Push up on the blue tabs until they lock into place.
Figure 22. Locking the 4-port card into position
5. If necessary, tighten the four captive screws that secure the air dam to the front of the embedded module.
6. Install the SFPs into the embedded module.
Install the embedded module cover
Steps
1. Position the cover over the embedded module and align it with the slots in the sides.
2. Pull the cover forward to secure it in place.
24
Base enclosure service procedures