Install The Terminal Block - National Instruments SCXI-1166 Installation Manual

4. Install the Terminal Block

NI SCXI-1366 Installation Guide
To connect the SCXI-1366 terminal block to the SCXI-1166 front panel,
complete the following steps:
1. Connect the terminal block front connectors to its mating connectors
on the terminal block.
2. Tighten the top and bottom thumbscrews on the back of the terminal
block rear panel to hold it securely in place.
1
1 SCXI-1166
2 Thumbscrews
Figure 3. Installing the SCXI-1366 Terminal Block
2
3
3 SCXI-1366 Terminal Block
4 Signal Wires
6
4
ni.com