Installing The Gps Module; Ush Daughter Board; Removing The Ush Daughter Board - Dell Latitude 14 Rugged Extreme Owner's Manual

b. base cover
3. To remove the GPS module:
a. Disconnect the GPS antenna cable from the module [1].
b. Release the GPS module from the connector on the system board [2].
c. Pull the GPS module retention latch upwards and remove the GPS module from the computer [3,
4].

Installing the GPS module

1. Align the GPS module with the connector on the system board.
2. Insert the GPS module into the slot.
3. Connect the GPS module antenna cable.
4. Install the:
a. base cover
b. battery
5. Follow the procedure in

USH daughter board

Removing the USH daughter board

1. Follow the procedure in
2. Remove the:
a. battery
b. base cover
c. hard drive or SSD
d. ExpressCard
3. To remove the USH daughter board:
a. Lift the release tab and pull the USH daughter board connector cable to disconnect it [1, 2].
b. Remove the screws that secure the USH daughter board to the chassis [3].
c. Turn the board over [4].
After working inside your
Before working inside your
computer.
computer.
35