Can Communication Connections - Lincoln Electric SPIRIT II 275 Technical Manual

Section 3: Installation

CAN Communication Connections

Perform the following steps to connect the plasma power supply to the MGC.
CAN Cable
35
• Connect the male end of the CAN cable to the connector labeled P4 on the rear of
the plasma power supply.
• Connect the female end of the CAN cable to the top connector on the rear of the
MGC.
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
35
35
3-22
Spirit II User's Manual