Table of Contents
Advertisement
WIRING INSTRUCTIONS FOR INSTALLING A DUAL SWITCH / RECEPTACLE
In order to install both the optional Blower and Accent Light acces-
sories, it will be necessary to install the junction box so that the
Duplex Receptacle wiring is split. This will allow each side of the
receptacle to operate independently off separate wall switches.
See diagram below.
BLACK
TO 120V
WHITE
CIRCUIT
BREAKER
GROUND
1.
To wire Junction Box Receptacle, remove the tab on the side
of the receptacle (hot side) to split receptacle. This will be
required to separate blower and Accent Light circuits.
2.
Power for switched and live sides of Duplex Receptacle must
come from the same power source. (One circuit breaker on
main panel must switch all power off.)
Page 26
DOUBLE SWITCH BOX
(INSTALLER PROVIDED)
DUAL SWITCH ELECTRICAL WIRING TO FIREPLACE RECEPTACLE
All wiring should be done by a qualified electrician and
shall be in compliance with all local, city and state build-
ing codes. Before making the electrical connection, make
sure that main power supply is disconnected. The appli-
ance, when installed, must be electrically grounded in ac-
cordance with local codes or, in the absence of local codes,
with the national electrical code ansi/nfpa 70 (latest edition).
#1
ACCENT LIGHT
WALL SWITCH
REMOVE TAB ON HOT SIDE
#2
OF DUPLEX RECEPTACLE
BLOWER
TO SPLIT LUGS
WALL
SWITCH
RED
BLACK
WHITE
3-WIRE, GROUNDED
CONDUCTOR
(BY OTHERS)
3. From the wall box to the fireplace a 3-wire conductor with
ground is recommended, however (2) two-wire conductors
with grounds may be used in place of a 3-wire conductor with
a ground if the black wires from the Accent Light and blower
accessories are identified.
4.
Two wall switches may be used to activate the two receptacle
plugs independently.
CAUTION
PLUG
FOR
CONTROLS
PLUG
FOR
BLOWER
FIREPLACE
CONTROL
COMPARTMENT
39813-2-0220
Advertisement
Table of Contents
