Table of Contents
Advertisement
2. Remove the bolts that fasten the machine to the
shipping skid.
3. Two lifting lugs are built into the machine, one of
which is shown at (A) Fig. 3. These lugs can be used to
mechanically lift the machine using a forklift and lifting
straps. NOTE: The other lifting lug is located at the rear
and the opposite end of the machine. Carefully remove
the planer from the shipping skid.
4. If it is necessary to lower the table (B) Fig. 3, to facil-
itate cleaning, loosen lock knob (C) and turn handwheel
(D) counterclockwise until the table (B) is at the desired
height for cleaning.
5. With allen wrench supplied, loosen and remove
screw (E) Fig. 4, from the left top edge of the machine
and raise the top cover (F) Fig. 5 as shown, exposing the
chipbreakers, and cutterhead. NOTE: The top cover of
the machine is hinged to facilitate cleaning and perform-
ing maintenance and adjustment procedures.
6. Carefully remove the protective coating from the table,
table rolls, infeed roll, anti-kickback fingers, cutterhead
and cutterhead knives. This protective coating may be
removed with a soft cloth moistened with kerosene.
(DO NOT USE GASOLINE, ACETONE, OR LACQUER
THINNER FOR THIS PURPOSE). CAUTION: Extreme
care should be taken when cleaning the knives as
the cutterhead knives are positioned in the cutter-
head and are very sharp.
7. After cleaning, cover the table surface with a good
quality paste wax.
8. Lower top cover and replace locking screw which
was removed in STEP 5.
ASSEMBLING
HANDWHEEL HANDLE
Thread handle assembly (A) Fig. 6, into handwheel (B)
and tighten locknut (C).
B
ASSEMBLY
6
Fig. 3
E
Fig. 4
F
Fig. 5
C
Fig. 6
A
C
D
A
B
Advertisement
Table of Contents
