Functional Description; Assembly - Delta 22-610 Instruction Manual

FOREWORD
The Delta Indusrial Model 22-610 is a 24-3/4" (629 mm) Planer with a 10 HP, three-phase motor capable of 230 V or
460 V operation with an LVC magnetic starter, 4-knife cutterhead, infeed and outfeed rollers, chipbreakers, dust chute,
knife-setting gauge, and wrench.
NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in the
manual are representative only and may not depict the actual labeling or accessories included. These are are intended
to illustrate technique only.
UNPACkINg AND CLEANINg
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
UNLOADINg AND POSITIONINg THE MACHINE
Use a crane with slings around and under the table
on both sides (Fig. 2) to unload this machine. Lift the
machine slowly, making sure that it is well balanced.
Lower it carefully.
Use rollers or some similar hauling device to push the
machine to the desired working site. Once the machine
is in position, level it and position it on hard rubber pads
placed underneath the four corners.
Remove the protective coating from the table, bed rolls,
feed rolls, and cutterhead with a stiff brush and/or soft
cloth moistened with kerosene. Do not use acetone,
gasoline or lacquer thinner for this purpose.
Take extreme care when cleaning the
cutterhead. The knives installed in the cutterhead
are very sharp.
After cleaning the table, cover the table surface with a
good quality paste wax.

FUNCTIONAL DESCRIPTION

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
Open end wrenches (supplied)
Hex wrenches (supplied)
Flat screwdriver (not supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 2 hours.
8
Fig. 2