Table of Contents
Advertisement
Preface: Read This First
All trademarks are the property of their respective owners.
1 Preface: Read This First
1.1 Sitara MCU+ Academy
™
Texas Instruments
offers the
on supported devices. The MCU+ Academy features easy-to-use training modules that range from the basics of
getting started to advanced development topics.
1.2 If You Need Assistance
If you have any feedback or questions, support for the Sitara MCUs and the AM263x Control Card development
kit is provided by the TI Product Information Center (PIC) and the
the PIC can be found on the
Documents.
1.3 Important Usage Notes
The E1 Control Cards have a known issue that will cause JTAG connection issues when using the
on-board XDS110 at speeds higher than 1 MHz. A small number of E1 sample devices have a slower
isolator (U53) installed that is limited to 1 MHz. If you are experiencing JTAG connections issues with
Code Composer Studio
TCLK Frequency of 1.0 MHz. To check the JTAG TCLK frequency of the target configuration:
1. Open the target configuration or create a new target configuration.
2. Click on the advanced tab to access advanced setup settings.
3. Click on Texas Instruments XDS110 USB Debug Probe_0 connection
4. Change the default setting for The JTAG TCLK Frequency (MHz) from "Fixed default 5.5-MHz
frequency" to "Fixed with user specified value"
5. Change the fixed user specified value from "5.5 MHz" to "1.0 MHz"
6. Click the Save button
7. Click Test Connection and confirm that there are no errors connecting to JTAG
The AM263x Control Card requires a 5 V, 3A power supply in order to function. While a USB type-C
cable is included, A 5 V, 3A power supply is not included in the kit and must be ordered separately
The
Belkin USB-C Wall Charger
For more information on power requirements refer to
power input then the red LED (LD16) will glow. For more information on power status LEDs refer to
Power Status
LEDs.
External Power Supply or Power Accessory Requirements:
•
Nominal output voltage: 5-VDC
•
Max output current: 3000 mA
•
Efficiency Level V
TI recommends using an external power supply or accessory which complies with applicable regional
safety standards such as (by example) UL, CSA, VDE,CCC,PSE, etc.
For a list of design changes for E2 of the AM263x Control Card, refer to
4
AM263x Control Card Hardware User's Guide
MCU+ Academy
as a resource for designing with the MCU+ software and tools
TI
website. Additional device-specific information can be found in the
Note
™
(CCS) IDE then ensure that the target configuration being used has a JTAG
Note
is known to work with the Control Card and supplied type-C cable.
Note
Note
Note
Copyright © 2023 Texas Instruments Incorporated
™
TI E2E
Forum. Contact information for
Power
Requirements. If there is an insufficient
E2 Design Changes
SPRUJ09C – MARCH 2022 – REVISED FEBRUARY 2023
www.ti.com
Reference
Submit Document Feedback
Advertisement
Table of Contents
