Changing The Turn Signal Bulb - KTM 690 SMC R 2017 Owner's Manual

14 ELECTRICAL SYSTEM
14.11

Changing the turn signal bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Tilt headlamp diffuser
–
Press the turn signal bulb lightly into the socket, turn it counterclockwise by about 30°,
and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until it
100160-10
stops.
Turn signal (RY10W / socket BAU15s) (
–
Position the diffuser.
–
Insert the screw and first turn counterclockwise until it engages in the thread with a
small jerk. Tighten the screw lightly.
Finishing work
–
Check that the turn signal system is functioning properly.

forward carefully and take it off.
p. 181)
134