KTM 690 SMC R 2017 Owner's Manual page 53

8 RIDING INSTRUCTIONS
Note
Engine failure Overheating damages the engine.
–
If the coolant temperature warning is displayed, stop immediately and take care not to endanger yourself or other traffic participants in
the process.
–
Allow the engine and cooling system to cool down.
–
Check and, if necessary, correct the coolant level on the cooling system while it is in a cooled state.
Info
If unusual noises arise during operation, stop immediately, switch off the engine, park the vehicle properly, and contact an autho-
rized KTM workshop.
–
Shift into a higher gear when conditions allow (incline, road situation, etc.).
–
Release the throttle while simultaneously pulling the clutch lever, shift into the next
gear, release the clutch lever, and open the throttle.
Info
You can see the positions of the 6 forward gears in the figure. The neutral or idle
position is between the first and second gears. First gear is used for starting off
or for steep inclines.
The operating temperature is reached when 5 bars of the temperature indicator
light up.
401950-11
–
After reaching maximum speed by fully opening the throttle grip, turn the throttle back
so it is ¾ open. This will barely reduce the speed but fuel consumption will be consid-
erably lower.
–
Accelerate only up to a speed suitable for the road surface and weather conditions. Par-
ticularly in bends, do not shift, and accelerate very carefully.
–
Brake if necessary and close the throttle at the same time in order to shift down.
51