Installing Matrox PowerStream
Plus software
Matrox PowerStream Plus software enables you to remotely control, manage,
and configure your Maevex devices from a controller system in your Maevex
environment.
Before you begin
You may need administrator rights to install or uninstall certain software. For more
information, see Windows documentation or contact your system administrator.
Windows Server 2019, Windows Server 2016, and Windows Server 2008 R2 – Make sure
the SSDP Discovery service, network discovery, and file sharing options are enabled. For
more information,
Make sure you're using a DHCP server. To assign an initial IP address to your devices, a
DHCP (Dynamic Host Configuration Protocol) server is required.
Supported operating systems
Matrox PowerStream Plus software supports the following operating systems:
Windows® Server® 2019
Windows® Server® 2016
Windows® 10 (64-bit)
Windows® 7
Windows® Server® 2008 R2
Software versions and mismatches
Make sure all of your Maevex devices are using the latest version of the Maevex firmware.
Also, all Maevex devices must use the same version of the firmware package.
The version of your firmware package must match the version of your PowerStream Plus
software package. If a mismatch is detected, your device won't be detected.
Obtaining Matrox PowerStream Plus software
Matrox makes the latest PowerStream software available on the Matrox web site
(www.matrox.com/maevexsw).
48 Matrox Maevex Series – User Guide
see page
50.