Validating Network Discovery - Matrox Maevex 6152 User Manual

Validating network discovery

Maevex devices are initially assigned their IP addresses through DHCP (Dynamic Host Control
Protocol). After connecting your devices, we recommend verifying that all of your devices are
discovered by the network.
Windows 10/7 – To make sure all of your devices are discovered by the network:
 Windows 10 – Click
all the Maevex devices connected are listed.
 Windows 7 – Click
Devices
If prompted to enable network discovery and file sharing on your network when validating network
discovery, enable these two features by clicking on the prompt at the top of your Windows Explorer
window. These two features must be enabled for PowerStream Plus software to detect the Maevex
devices.
After validating your connection setup, install Matrox PowerStream Plus software
Matrox PowerStream Plus software", page
44 Matrox Maevex Series – User Guide

Start File Explorer

Start Acessories
, make sure all the Maevex devices connected are listed.
48).
 . Under
Network Other Devices
 
Windows Explorer
, make sure
. Under
Network Other
(see "Installing