Marking [Mark] - JRC JMA-5204 Instruction Manual

3.5.16 Marking [MARK]

A maximum of 20 marks can be indicated at arbitrary positions on the radar display.
A mark created on the radar display holds the latitude and longitude.
[I] Creating Marks
Procedure 1
2
Note: If more than 20 marks are created, the oldest mark is cleared and the newly created mark is
displayed.
[II] Clearing Marks
Procedure 1
2
* Software button
the cursor mode. When " " appears, the cross cursor is available to create " " mark.
Press [MARK] key.
[ ] will appear in the CURSOR field at the upper right of the radar display.
Put the cross cursor mark
created, and press [ENT] key.
The cross cursor mark
display. To enter more [ ] marks, repeat step 2.
Up to 20 marks can be entered.
Press [MARK] key.
The [ ] mark will appear in the CURSOR field at the upper right of the radar display.
Put the cross cursor mark
The [ ] mark will disappear. To clear another [ ] mark, repeat step 2.
To clear all [ ] marks, press [MARK] key and then hold down [CLR] key.
located at the top right corner of the radar display described in Section 2.3.3 changes
+ on the position where a mark is to be
+ will be changed into the [ ] mark and fixed on the radar
+ on the mark to be cleared.
3 59