Table of Contents
Advertisement
10
Cleaning and Maintenance
General Tips
– Before cleaning the hob switch it off and wait for it to cool down.
– Clean with a cloth, hot water and soap or liquid detergent.
– Do not use products which are abrasive, corrosive or chlorine based.
– Do not use steel pads.
– Avoid using cleaning products with a chlorine or acidic base.
– Do not leave acid or alkaline substances (vinegar, salt, lemon juice, etc.)
on the hob.
– Steam cleaners must not be used when cleaning this appliance.
– Warning: When correctly installed, your product meets all safety
requirements laid down for this type of product category. However special
care should be taken around the underneath of the appliance as this area
is not designed or intended to be touched and may contain sharp or rough
edges, that may cause injury.
Glass Surface
– Remove spillages and other types of incrustations by using only specific
products which do not contain abrasives or chlorine-based acids.
– If you use a detergent, please make sure that it is not abrasive or scouring. Abrasive or scouring powders
can damage the glass surface of the hob.
– All traces of the cleaner must be removed with a damp cloth.
– Dust or food particles can be removed with a damp cloth.
– Dust, fat and liquids from food that has boiled over must be removed as soon as possible.
– If they are allowed to harden they become increasingly difficult to remove. This is especially true in the
case of sugar/syrup mixtures which could permanently damage the surface of the hob if left to burn
on it.
– Avoid using a knife or other sharp utensil as these may damage the glass surface.
– Do not use steel wool or an abrasive sponge which could scratch the surface permanently.
– Do not put articles on the hob which can melt: i.e plastic, aluminium foil, sugar, sugar syrup mixtures etc.
Stainless Steel Surfaces
– Stainless steel parts should be rinsed with water and dried with a soft cloth.
– For persistent dirt, use specific non-abrasive products available commercially or a little hot vinegar.
Control Knob/s
– The control knobs may be removed for cleaning but care should be taken not to damage the seal.
CAUTION:
Do not use harsh
abrasive cleaners
or sharp metal
scrapers to clean the
glass since they can
scratch the surface,
which may result
in shattering of the
glass.
Advertisement
Table of Contents
