26
10. Check the air shutter following the directions below.
Air Shutter Adjustment
Let the heater burn for fifteen minutes (make sure the logs and glass are in place). The flames should be
yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
11. Turn the flame adjust knob to its highest position - the flames should not contact the top of the firebox. Check the flame
on low position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your Travis
dealer for a remedy.
12. Give this manual to the home owner for future reference and fully explain operation of this heater.
© Travis Industries
Installation
(for qualified installers only)
2/23/18 - 1479
Greenfield GSR2-Aust