Installation
Approved Vent Configurations
Exhaust Restrictor Position
•
An exhaust restrictor is built into the appliance to control the flow rate of exhaust gases. This
ensures proper flames for the wide variety of vent configurations. Depending upon the vent
configuration, you may be required to adjust the restrictor position. The charts for approved vent
configurations describe which position the vent restrictor should be in.
NOTE:
If the vent configuration calls for restrictor removal, replace the screws into the holes
in the firebox ceiling to seal the firebox.
© Travis Industries
(for qualified installers only)
2/23/18 - 1479
Greenfield GSR2-Aust
13