Index - National Instruments VXIpc-745-100 User Manual

Index

Numbers
32-bit registers, accessing, E-1
A
ACCESS LED, 1-6, C-3
address map, I/O (table), B-3 to B-4
application-specific interface chips, custom,
1-4 to 1-5
B
BIOS. See also CMOS.
clearing CMOS contents, 3-7
default setup settings, 4-1
entering setup, 4-1
viewing settings, E-3
board access LEDs, C-3
bulletin board support, F-1
C
cable, optional, 1-2
CLK10 signal, accuracy of, E-1
CMOS. See also BIOS.
PC configuration, 3-7
setting back to default, E-3
COM1 connector and signals, D-8 to D-9
common questions about VXIpc 700 Series,
E-1 to E-3
configuration
default settings, 3-1 to 3-3
factory default settings (table), 3-3
parts locator diagram, 3-2
EEPROM, 3-5 to 3-7
configuration settings (figure), 3-6
fixing invalid configuration, 3-6 to 3-7
© National Instruments Corporation
power-on self configuration status
(figure), 3-5
protecting against electrical hazards
(warning), 3-6
electrostatic discharge (warning), 3-1
installed system RAM, 3-7
installing VXIpc-700 Series, 3-8 to 3-9
PC configuration, 3-7 to 3-8
Ethernet power-on defaults, 3-8
system CMOS, 3-7
removing metal enclosure, 3-3
trigger input termination, 3-5
viewing BIOS settings, E-3
VXIbus Slot 0/non-Slot 0, 3-4
connectors. See also signals.
COM1 (figure), D-8 to D-9
Ethernet (figure), D-7
external SMBs (figure), D-12
front panel connectors (table), 1-5, D-1
GPIB (IEEE-488.2) (figure), D-10 to D-11
keyboard (figure), D-4
signal characteristics (table), D-13
VGA (figure), D-5 to D-6
VXIbus P1 and P2, D-114
custom application-specific interface chips,
1-4 to 1-5
customer communication, xii, F-1 to F-2
D
default settings, 3-1 to 3-3
factory default settings (table), 3-3
parts locator diagram, 3-2
disk drives. See IDE controller.
DMA channel resource allocations (table), B-2
I-1 VXIpc 700 Series User Manual