Table D-7. Smb Connector Signals - National Instruments VXIpc-745-100 User Manual

Appendix D Front Panel and Connectors
External SMBs
VXIpc 700 Series User Manual
Figure D-8 shows the location and pinouts for the SMB connectors on the
VXIpc-700. The SMB connectors are used for an external clock signal and
TTL trigger input and output. Table D-7 gives the name and description for
the SMB connector signals. Also see Table D-8 for a description of the
signal characteristics for the SMB connections.
Amp manufactures an SMB mating connector, part number 1-413985-0.
FAILED SYSF
ONLINE TEST
ACC
DRIVE
G
P
I
B
1
RESET
TM
VXIpc -740
a. VXIpc-745
Figure D-8. SMB Connectors Location and Pinout

Table D-7. SMB Connector Signals

Pin
Center
Shield
FAILED
ONLINE
DRIVE
Center
Shield
RESET
VXIpc -740
b. VXIpc-740
Signal Description
TTL Trigger or Clock Signal
Ground
D-12
SYSF
TEST
ACC
Center
Shield
1
TM
© National Instruments Corporation