National Instruments VXIpc-745-100 User Manual page 31

© National Instruments Corporation
4. Insert the VXIpc-700 in the slot you have selected by aligning the
top and bottom of the module with the card-edge guides inside the
mainframe. Slowly push the VXIpc-700 straight into the slot until its
plug connectors are resting on the backplane receptacle connectors.
Using slow, evenly distributed pressure, press the module straight in
until it seats in the expansion slot. The front panel of the VXIpc-700
should be even with the front panel of the mainframe.
5. Tighten the retaining screws on the top and bottom edges of the front
panel.
6. Check the installation.
7. Connect the keyboard and mouse to the appropriate connectors. Use
the keyboard adapter cable that you received with your kit to adapt
AT-style keyboards to the VXIpc-700 mini-DIN connector. Connect
the mouse to the COM1 serial port.
8. Connect the VGA monitor video cable to the VGA connector.
9. Connect devices to ports as required by your system configuration.
10. Replace or close any doors or covers to the mainframe.
Chapter 3 VXIpc 700 Series Configuration and Installation
3-9 VXIpc 700 Series User Manual