Table of Contents
Advertisement
WORK
Removing the seat
3.1
Mounting the seat
3.2
Recharging the battery
3.3
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.
Warning
Environmental hazard Battery parts and acid are harmful to the environment.
–
Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner.
Give the battery to your KTM dealer or to a recycling center that accepts used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Pull on strap
–
Pull back the seat and lift it off.
100230-10
(690 Enduro)
–
Hook slot
same time push it forward.
–
Push locking pin
until the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
100276-10
(690 Enduro R)
–
Hook slot
same time push it forward.
–
Push locking pin
until the locking pin locks in place with an audible click.
–
Finally, check that the seat is correctly mounted.
800096-10
and raise the rear of the seat at the same time.
of the seat onto screw
, press the rear downward and at the
into lock housing
of the seat onto screw
, press the rear downward and at the
into lock housing
and push the back of the seat down
and push the back of the seat down
6
Advertisement
Table of Contents
