KTM 690 Enduro EU 2010 Setup Instructions page 6

SET‑UP
–
Mount and tighten the rear mirror adapter and rear mirror on both sides.
–
Exactly position all controls on the handlebar. Tighten all screws.
–
Fit and tighten the M8 screw of the right hand guard.
100309-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Plier for footrest spring (58429083000)
–
Remove the protective plastic.
–
Carefully loosen and remove the tensioning belt over the link fork.
Info
An assistant prevents the motorcycle from falling over.
100308-01
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the palette.
–
Recharge the battery. (
–
Connect plug
B00247-12
–
Remove the rear fairing. (
–
Four markings
tions, drill holes in three steps of the prescribed size.
Guideline
Hole diameter for grab handles
B00248-10
–
Remove screws
–
Fit the rear fairing. (
B00249-10
–
Mount the reflector.
700217-01
p. 6)
to the starter relay.

p. 8)
can be seen on the underside of the rear fairing. At these posi-

.

p. 9)
14.50 mm (0.5709 in)
4