KTM 690 Enduro EU 2010 Setup Instructions page 5

SET‑UP
Unpacking and setting up the vehicle
2.1
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle during assembly, leave the protective film
on the vehicle until you have finished.
–
Check the vehicle for transport damage.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
100302-01
–
Remove the controls from the transport holder. Remove the screws and handlebar
clamps. Remove the transport holder.
100303-01
–
Remove the M8 screw from the right hand guard.
100318-10
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
100306-10
–
Position the handlebar.
The mark 1 of the scale on the handlebar should be centered on the handlebar
clamp.
–
Position the handlebar clamps. Mount and evenly tighten the four screws.
Guideline
Screw, handlebar clamp
100305-10
–
Position the controls on the left half of the handlebar. Mount the screws.
100307-01
M8 20 Nm
(14.8 lbf ft)
3
Loctite ® 243™