Reconfiguring the Detector
(Not applicable to the GasAlertClip Extreme)
The detector can be reconfigured prior to performing a bump
check or calibration to change the alarm setpoints and other
settings.
Fleet Manager
•
GasAlert Extreme
•
GasAlertMicro
•
GasAlertMicro 5 and GasAlertMicro 5 PID
•
GasAlertMicroClip
Changing Settings
1.
Ensure that a correctly formatted MultiMediaCard
(MMC) is inserted in the station. Refer to
Inserting/Replacing a
2.
Connect the USB cable to the computer and to the
USB port on the station.
3.
Activate the detector and wait until it is in normal
operating mode. Insert it into the detector bay.
MMC.
4.
Activate the station.
5.
From the computer, open Fleet Manager.
6.
Located at the bottom of the left menu bar, click
Administrator.
7.
Enter your password in the password pop-up.
8.
From the left menu bar, click the Configure
Detectors icon.
9.
The configuration pop-up displays. Select either
•
Load Existing MicroDock Configuration
File (select to use an existing file to
configure/reconfigure a detector), or
•
Create New MicroDock Configuration File
(select to create a new configuration file to
configure/reconfigure a detector).
10. Click the tab of the required detector
(e.g. GasAlertMicro 5) to access the
corresponding configuration screen.
MicroDock II
Reconfiguring the Detector
45