Getting Started; Powering On And Initial Setup - BenQ Portable Series User Manual

Getting started

Powering on and initial setup

1. Choose a preferred location and image size as instructed in
a location" on page
See "Installing the ATV dongle" on page 25
2. Install the remote control's batteries.
Before you can begin to use the remote control, you must install the
supplied batteries into the remote control.
• Slide the battery cover outwards.
• Insert the batteries in the orientation shown below.
• Slide the battery cover back onto the remote control.
Note
Avoid leaving the remote control and batteries in an excessively hot or humid environment like the
kitchen, bathroom, sauna, sunroom or in a closed car.
3. Connect power to the projector. If you are starting up the projector for
the first time, charge the battery or supply power to the projector until
the power LED lights up in green. See
27 for more information.
Press and hold the power button
The power LED will flash green slowly.
21. Make sure the ATV dongle has been installed.
28
for more details.
"Charging the battery" on page
on the projector for 3 seconds.
"Choosing