Table of Contents
Advertisement
5. Press the IRIS CLOSE/OPEN buttons to close/open the
lens iris. Adjust the lens iris by using these buttons to
obtain the proper picture exposure.
Pressing these buttons at the same time for three sec-
onds or more will reset the lens iris to the factory default
setting.
Note: When a camera, with an ALC Lens, has AGC
turned on, the iris close, open function will operate
more slowly. By pressing the above buttons repeat-
edly (instead of holding down), this function will
operate faster.
6. If Lens Control needs fine adjustment, follow the proce-
dures shown below.
1) Select the desired monitor and camera.
2) Select the P/T Z/F Iris (B3) Menu on the LCD dis-
play by pressing the Direction buttons.
B3
P/T Z/F Iris
3) Pressing the Focus, Zoom or Iris control while
holding down the Function (F1) button will adjust
the focus, zoom or lens iris step by step.
Note: Holding down the STOP/SLOW button and
5
pressing the Focus, Zoom or Iris control, while the
ALT indicator is on, will adjust the focus, zoom or
lens iris step by step without displaying the P/T Z/F
Iris Menu.
100
IRIS
CLOSE OPEN
Step
F1
Pan/Tilt Control (Manual Operation)
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection on
page 98.
2. Select a mode by pressing the [F3] or [F4] button.
" " indicates the currently selected mode.
A1
Camera
cc
Monitor mm
SLW: Moves the Pan/Tilt Head at lower speed.
FST: Moves the Pan/Tilt Head at higher speed.
Note: This function is available with the WV-CU550CJ
system controller.
3. Move the Joystick Controller to move the Pan/Tilt Head
in the desired direction.
If the joystick is positioned in between } and {, the
Pan/Tilt Head moves diagonally upward and to the
right.
Eight directions are available: Up/Down/Right/Left/Up-
Right/Up-Left/Down-Right/Down-Left.
Up
Left
Down
Note: When FST mode is selected, moving the Joystick
Controller while holding down the STOP/SLOW but-
ton will move the Pan/Tilt Head at lower speed.
4. If the Pan/Tilt Control needs fine adjustment, follow the
procedures shown below.
1) Select the desired monitor and camera.
2) Select the P/T Z/F Iris (B3) Menu on the LCD dis-
play by pressing the Direction buttons.
B3
P/T Z/F Iris
Step
F1
3) Moving the Joystick Controller while holding down
the Function (F1) button will move the Pan/Tilt Head
step by step.
Note: Holding down the STOP/SLOW button and mov-
ing the Joystick Controller, while the ALT indicator
is on, will move the Pan/Tilt Head step by step with-
out displaying the P/T Z/F Iris Menu.
SLW
FST
F3 F4
Right
Advertisement
Table of Contents
