Table of Contents
Advertisement
5. The test function stops automatically, and the LCD dis-
play reads as shown below.
Press the Function (F4) button to exit from the test
mode. The display will return to the previous CAM-P
Menu.
Test1 CAM-P9999 End
Camera Position Mode Selection
Operation by camera position number is available only
when CAM-P Mode is set to On mode.
1. Select the CAM-P (D5) Menu shown below on the LCD
display by pressing the appropriate Direction button.
D5
CAM-P Menu
Set Clear Test Mode
2. Pressing the Function (F4) button will display the menu
shown below on the LCD display.
CAM-P Mode Off
5
Press the Function (F1) button to toggle the mode on
and off.
3. Press the Function (F4) button to exit from the setup
mode. The display will return to the previous CAM-P
Menu.
Note: Selecting On mode on the LCD display enables
the MON (ESC) key to execute the selection.
When selecting the monitor, enter the desired moni-
tor number by pressing the Numeric keys, and then
press the Function (F1) button instead of the MON
(ESC) key while the Monitor Selection (A1) Menu is
displayed.
123
-Act
Exit
F1 F2
F3 F4
F1 F2
F3 F4
On
Exit
F1 F2
F3 F4
Priority Lock
This function is used by an operator to retain control of a
monitor, even after that operator has selected another mon-
itor or has logged out.
1. Select the Priority Lock (A4) Menu on the LCD display
by pressing the appropriate Direction button.
2. Press the Function (F1) button to select the Priority Lock
mode on the active monitor.
The monitor number is inversely displayed on the active
monitor, as shown below.
A4
PriorityLock
On Off
Auto Log-Out
P
F1 F2
F3 F4
3. Press the Function (F2) button to release the priority
lock.
The monitor number is displayed normally on the moni-
tor.
Note: This function will prevent operators with a lower
priority from gaining control of a monitor.
However, higher priority operators may still gain
control of that monitor.
M16
Advertisement
Table of Contents
