Table of Contents
Advertisement
Group Sequence
A Group Sequence consists of up to 64 steps.
In each step, a maximum of 16 cameras can be assigned to 16 monitors.
Pan/Tilt preset and Auxiliary control (1 & 2) can also be set for each camera/monitor combination.
Camera view switching (Dwell Time) for each step can be set from 1 second to 30 seconds in 1-second increments.
There are 8 Group Sequences available, with programming performed on the Set Up Menu.
1
Timer Event
The timer function is used to program and automatically activate Tour or Group Sequences according to the time of day, day
of week and 5 user defined special days.
There are 45 timer events available in one day.
Alarm Control
Alarm Input
There are 2 kinds of alarm inputs available in the system.
• Camera Site Alarm
This alarm signal is supplied from the associated camera site receiver or camera.
Receivers capable of camera site alarm input are models WV-RC100, WV-RC150 and WV-RC170.
• Interface Alarm
This alarm signal is supplied from the Alarm Input (ALARM IN) Connector on the optional Alarm Boards installed in the WJ-
SX550C Matrix Switcher.
Up to 128 alarm inputs are available.
• Alarm Operation Modes
There are three alarm operation modes available in the WJ-SX550C Matrix Switcher.
The alarm modes can be switched according to the time programmed on an internal timer.
12
4th Floor
C 13
C 14
C 15
3rd Floor
C 9
C 10
C 11
2nd Floor
C 5
C 6
C 7
1st Floor
C 1
C 2
C 3
Group Sequence
C 16
CAM 13
CAM 14
C 12
CAM 9
CAM 10
C 8
CAM 5
CAM 6
C 4
CAM 1
CAM 2
Monitor 1
Monitor 2
CAM 15
CAM 16
CAM 11
CAM 12
CAM 7
CAM 8
CAM 3
CAM 4
Monitor 3
Monitor 4
Advertisement
Table of Contents
