Table of Contents
Advertisement
Synchronizing the Sequence
with External Timing
The camera switching interval (Sequence Dwell Time) can
be synchronized with the time lapse mode set in the associ-
ated Time Lapse VTR.
Select the On or Off mode on the EXT Timing Select table to
meet each monitor's requirements.
Caution: Set the interval time for the external timing signal
of the external equipment to 1 second or more.
If the interval is set to less than 1 second, the system
will not work properly.
1
Cable Compensation/VD2
Cable Compensation
This feature is used to compensate for signal loss due to
cable length.
The most suitable position for cable-loss compensation can
be selected in the Set Up Menu.
Available cable length compensations are shown
below.
S:
Up to 500 m (1 600 ft)
M:
500 m (1 600 ft) to 900 m (2 900 ft)
L:
900 m (2 900 ft) to 1 200 m (4 000 ft)
(When using RG-6/U or equivalent)
VD2 (Vertical Drive Sync Signal)
The VD2 (Vertical Drive Sync Signal) can be turned On or
Off by using the Set Up Menu.
Select VD2 On or Off to meet camera requirements.
RS-485 Site Communication
The parameters for communication with the Camera Site
can be set on the RS-485 Site Communication table in the
Set Up Menu, if the optional WV-PB5548E Data Board is
installed in the Matrix Switcher.
(The WV-RM70 Camera Controller or a modem may be
required in the system.)
Note: Be sure to select the correct Baud rate when using a
modem.
Clock
On-screen clock display is available.
The date and time can be set on the Clock Set table.
17
Printer
A parallel printer can be used to print out the Status, Alarm
Recall or Setup data.
The recommended printer to use is the Panasonic KX-
P1624 Impact Dot Matrix Printer.
RS-232C Port
This port is used for connecting with a Personal Computer.
The memory of the WJ-SX550C Matrix Switcher can be
loaded or saved.
A Personal Computer can be substituted for the WV-
CU550CJ System Controller to control the system.
Note: For using a Personal Computer, you will need special
software offered separately.
Advertisement
Table of Contents
