Cord; Using Cord With The Buttonhole Foot With Slide #3A - Bernina 790 PRO Manual

Buttonholes
> For keyhole and round buttonholes mark the lenght of the bead with chalk or a water-soluble pen on the

9.5 Cord

Using Cord with the Buttonhole Foot with Slide #3A
The additional cord reinforces and embellishes the buttonhole and is particularly suitable for the Buttonhole
51. Ideal cords are Perle cotton No. 8, strong hand-sewing thread and fine crochet yarn. It is recommended
to not hold the cord while sewing.
•
> Insert the needle at the beginning of the buttonhole.
> Guide the cord on the right side under the Buttonhole Foot with Slide.
> Hook the cord over the pin at the back of the Buttonhole Foot with Slide.
> Pull the cord on the left side under the Buttonhole Foot with Slide to the front.
> Pull the cord ends into the slits.
> Lower the Buttonhole Foot with Slide.
> Sew the buttonhole in the usual manner.
> Pull the cord loop until the loop disappears in the bartack.
114
fabric. For any subsequent buttonholes mark the starting point. The length of the keyhole is sewn
additionally.
The Buttonhole Foot with Slide #3A is fitted and raised.