Page 4
® Copyright 1998 Ariens Company All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of the Ariens Company. Ariens®...
6. If the transmission operates irregularly the transmission needs to be bled. 7. Verify that the transmission lines and elbows are sloping upward toward the expansion tank. Remove straps holding the hoses down. Hydrogear transaxle 5-29 Ariens® 01546200 Orig. 9/98...
Page 35
NOTE: Prior to reassembly the lower and rear covers must be thoroughly cleaned and old sealant must be removed. NOTE: The lip seals must not be re-used during reassembly. 10. Inspect the final drive gear teeth for excessive wear or damage. Seals 5-30 Ariens® 01546200 Orig. 9/98...
Page 41
Reattach the negative lead to the battery, and the needed. ignition coil lead to the spark plug(s) on the engine. 4. Insert the spindle shaft into the spindle housing. Hold in place with a flat washer, lock washer, and grade 5 01546200 Orig. 9/98 Ariens® 6-34...