Honda CL360 Owner's Manual page 74

Rear Wheel Removal
1. Place the motorcycle on its center
stand .
2. Unscrew the rear brake adjusting nut
CD ~
disconnect the brake rod @
from the brake arm
®
and disconnect
the stopper arm
©
from the backing
plate @ by removing the cotter pin,
stopper arm nut
® ,
washer and rub-
ber grommet.
3. Remove the cotter pin
(j)
from the
end of the axle .
4 . Unscrew the rear axle nut @ and pull
out the rear wheel axle . Pull the wheel
forward and derail the drive chain
from the rear sprocket. Tilt the
motorcycle to one side so that the
wheel can be removed.
5. To install the rear wheel, reverse the
removal procedure. Always use a new
cotter pin after tighten the axle nut
to 800-1000 kg-cm (58-73 lbs. ft.) .
68
r
CD
Rear brake adjusting nut ® Brake rod
® Brake arm © Stopper arm
@ Backing plate ®Stopper arm nut
,.\
' /
(j)
Cotter pin ® Axle nut