Honda CL360 Owner's Manual page 46

2. If left cylinder ignition timing is in-
correct, loosen the base plate locking
screws@, and rotate the base plate
@
to obtain correct timing. Rotate the
base plate clockwise to advance
timing, or counterclockwise to retard
timing. Tighten the base plate locking
screws and recheck left breaker point
gap.
3. Turn the generator rotor
®
coun-
terclockwise until the "F" timing
mark
®
on the rotor aligns with the
index mark® on the generator stator
®.
If right cylinder ignition timing is
correct, the right breaker points will
just begin to open as these marks align.
4. If right cylinder timing is incorrect,
loosen the right breaker plate locking
screws
@,
and increase or decrease
point gap to obtain correct timing. Do
not loosen the base plate locking
screws @. Increasing the point gap
40
advances ignition timing. Decreasing
the point gap retards ignition timing.
®
Base plate locking screws @ Base plate
@ L /H contact breaker plate locking screws
@
R/ H
contact breaker plate locking screv:s
NOTE:
Ignition point gap must remain within
limits of 0.3-0.4 mm (0.012-0.016
in.) after ignition timing has been set.
If correct timing results in a point gap