Disconnecting/Connecting Coaxial Cables; Coaxial Cable With Connector - Sony F35 Maintenance Manual

8. Remove the four screws (M2.6).
9. Remove the six screws to detach the MB-1100 board,
MB bracket (A), and MB bracket (B).
10. Remove the two screws (M2) to detach the connector
board holder.
MB-1100 board
MB bracket (A)
B2.6 x 6
Screws (M2)
Screws (M2.6)
B2.6 x 6
MB bracket (B)
11. Install the MB-1100 board by reversing the steps
above.
n
For connecting the coaxial cable, refer to Section 2-10-
2.
2-26
Connector board holder
2-10. Disconnecting/Connecting Coaxial
Cables

2-10-1. Coaxial Cable with Connector

Notes on Disconnecting
The coaxial cable with connector uses fine pitch coaxial
cables. Be careful when handling the cable.
When disconnecting the coaxial cable with connector, be
sure to hold the connector. Do not pull the cable.
Hold the connector to remove.
OK
Do not attempt to remove by pulling
NG
the cables.
Notes on Connecting
When connecting the coaxial cable with connector, hold
the connector matching the polarity marks and insert the
coaxial cable straight into the corresponding connector.
Terminal side
Hold the connector to connect.
OK
Not to bend the cable.
NG
Polarity marks
Yellow
F35