Description Of Ccd Block Number; Optional Fixtures; Notes On Repair Parts; Unleaded Solder - Sony F35 Maintenance Manual

1-12. Description of CCD Block Number

Every CCD unit has its own ID number called CCD block
number. It shows the CCD block type and serial number
for the CCD block.
The CCD block number label is put in the CCD unit.
Example : OBA xxxxx
Serial number for the CCD unit
CCD block type
Model CCD block type
F35 OBA
For replacing the CCD unit, refer to Section 2-1.

1-13. Optional Fixtures

Name
*1
EX-1030 Board
*2
PLD download fixture
DC-OUT 12V connector nut fixture
DC-OUT 24V connector nut fixture
LEMO-1B type connector nut fixture
*1: For extension of plug-in boards
*2: PLD data download cable
1-18

1-14. Notes on Repair Parts

1. Safety Related Components Warning
2. Standardization of Parts
3. Stock of Parts
4. Harness
Sony Part No.
A-1252-824-A
J-7120-140-A

1-15. Unleaded Solder

J-6602-260-F
J-6602-250-F
Boards requiring use of unleaded solder are printed with a
J-6602-220-F
lead free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come
printed with the lead free mark due to their particular size.)
m
. Be sure to use the unleaded solder for the printed circuit
. The unleaded solder melts at a temperature about 40 dC
. The ordinary soldering iron can be used but the iron tip
w
Components marked ! are critical to safe operation.
Therefore, specified parts should be used in the case of
replacement.
Some repair parts supplied by Sony differ from those
used for the unit. These are because of parts common-
ality and improvement.
Parts list has the present standardized repair parts.
Parts marked with "o" at SP (Supply Code) column of
the spare parts list may not be stocked. Therefore, the
delivery date will be delayed.
Harnesses with no part number are not registered as
spare parts.
: LEAD FREE MARK
board printed with the lead free mark.
higher than the ordinary solder, therefore, it is recom-
mended to use the soldering iron having a temperature
regulator.
has to be applied to the solder joint for a slightly longer
time. The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful.
F35