Connecting The Cables; Mounting On A Tripod; When Mounting The Camera - Sony XCU-CG160 Technical Manual

Connecting the cables

Connect the camera cable (
input connector ( ), and connect a USB 3.0 cable (
2
the USB connector ( ). If using a USB 3.0 interface
1
image input board or a hub, you can operate the camera
even if you do not connect the camera cable to the DC
power supply input connector.
It you connect a USB 3.0 cable that has fastening
screws, turn the two screws (
secure the cable tightly.
Connect the other end of the USB 3.0 cable to the USB
3.0 interface image input board or a hub.

Mounting on a tripod

To use a tripod, attach the VCT-333I Tripod Adaptor
(not supplied) to the camera module.
Use a tripod screw that protrudes (4) beyond the
mounting surface, as follows, and tighten it using a
screwdriver. Be sure that the protrusion (4) does not
exceed 5.5 mm (0.2 in.) in length.
4: 4.5 mm to 5.5 mm
Note
When attaching the tripod adaptor (not supplied), use
the screws provided with the tripod adaptor.

When mounting the camera

When the value read from temperature sensor is above
75 °C (167 °F), heat dissipation is required.
Use in environments where the difference with the
ambient temperature is 32 °C (90 °F) or less.
To facilitate heat dissipation from the unit and maintain
performance, mount the camera to a metallic plate.
Notes
• When mounting the camera on the metallic plate,
secure the camera by using the reference screw holes
on the camera (page 5) and screws.
• Do not mount the camera on a plate made of a
material, such as wood or resin, that prevents heat
dissipation.
) to the DC power supply
5
3
) on the connector to
4
Metallic base plate
) to
Plate that prevents heat dissipation
(made of wood, resin, etc.)
Plate that prevents heat dissipation
(made of wood, resin, etc.)
7
Metallic base plate