Precaution On Replacing The Sy-255 Board; Method For Copying Or Erasing The Data In Internal Memory - Sony Cyber-shot DSC-H55 Service Manual

1-1. PRECAUTION ON REPLACING THE SY-255 BOARD

DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the "DESTINATION DATA WRITE".
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "RESTORE DATA" to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
• AWB standard data input & check, Color reproduction check
• Strobe adjustment
• Wide Limit adjustment
Regarding the PMB Portable
PMB Portable has been written in internal memory.
SY-255 board for service is supplied with written the PMB Portable.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the "USB SERIAL No. INPUT".
Angular Velocity Sensor
When you replace to the repairing board, write down the sensitivity displayed on the angular velocity sensor (SE401).
Start the Adjust Manual in the Adjust Station and execute the "Angular velocity sensor sensitivity adj".
SY-255 BOARD (SIDE B)
PPP: PITCH sensor
S E 4 0 1
sensitivity
P P P
YYY: YAW sensor
Y Y Y
sensitivity
Note: The sensor sensitivity of SE401 of SY-255 board is written only repair parts.
DSC-H55_L2
1. SERVICE NOTE

1-2. METHOD FOR COPYING OR ERASING THE DATA IN INTERNAL MEMORY

The data can be copied/erased by the operations on the HOME screen. (When erasing the data, execute formatting the internal memory.)
Note 1:When replacing the SY-255 board, erase the data in internal memory of the board before replacement.
Note 2:When replacing the SY-255 board, execute formatting and initialize the internal memory after replacement.
Method for Copying the Data in Internal Memory
Copy
Copies all images in the internal memory to a memory card.
1 Insert a memory card with sufficient free capacity into the camera.
2 MENU t (Settings) t
t z on the control button
Notes
• Use a fully charged battery pack. If you attempt to copy image files using a battery pack with little
remaining charge, the battery pack may run out, causing copying to fail or possibly corrupting the data.
• Images cannot be copied individually.
• The original images in the internal memory are retained even after copying. To delete the contents of the
internal memory, remove the memory card after copying, then format the internal memory ([Format] in
[Internal Memory Tool]).
• A new folder is created on the memory card and all the data will be copied to it. You cannot choose a
specific folder and copy images to it.
Method for Formatting the Internal Memory or Memory Card media
Format
Formats the memory card or the internal memory. When you use a memory card with this
camera for the first time, it is recommended to format the card using the camera for stable
performance of the memory card before shooting. Note that formatting permanently erases all
data on the memory card, and is unrecoverable. Save precious data on a computer, etc.
1 MENU t (Settings) t
Memory Tool) t [Format] t [OK] t z on the control button
Note
• Note that formatting permanently erases all data including even protected images.
1-1
(Memory Card Tool) t [Copy] t [OK]
(Memory Card Tool) or (Internal