Protective Conductor Test - Siemens Polymobil 10 Maintenance Manual

2 - 12
2.11

Protective conductor test

SIE Protective conductor test
Observe the protective conductor resistance test information in these instructions.
•
The protective conductor test is to be performed on a closed system according
to ARTD-002.731.17...
•
The protective conductor resistance must not exceed 0.2 Ohms.
•
The values determined must be recorded and assessed in the protective conductor
resistance report and include the measured points.
•
In addition, document the measuring method and the measuring instrument used
(designation and serial number).
......
NOTE
NOTE
Polymobil 10
The protective conductor resistance report is filed in the
"Certificates" register in the system binder.
A new report must be created if the protective conductor resis-
tance measurements are not documented.
These instructions contain a new report called 'Protective con-
ductor resistance/report'. Separate this report, fill it out, and file
it in the system manual under "Certificates". If values are newly
determined, they are to be recorded as first measured values.
The evaluation is omitted in this case.
RXR8-120.101.01
Rev. 05
Inspection and maintenance
Page 12 of 14
07.05 CS PS 24
Siemens AG
Medical Solutions