MULTIQUIP WM90SE Operation Manual page 39

SUSPENSION
The rigid suspension and associated components (Figure 50)
should be visually inspected monthly for signs of excessive
wear, elongation of bolt holes or loosening of the mounting
bracket. Replace any damaged suspension components
immediately.
LOCK
NUT
Figure 50. Suspension Components
WM90 SERIES PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #2 (10/30/19) — PAGE 39
FLAT
WASHER
MOUNTING
BOLTS
CHECK FOR
TIGHTNESS
MOUNTING
BRACKET
RIGID TYPE
AXLE
MAINTENANCE (MIXER)
LONG-TERM STORAGE
For storage of the mixer for over 30 days, the following is
recommended:
„ Drain the fuel tank completely, or add STA-BIL
fuel.
„ Run the engine until the gasoline in the carburetor is
completely consumed.
„ Completely drain the oil from the crankcase and refill
with fresh oil.
„ Remove the spark plug, pour 2–3 cc of SAE 30 oil into
the cylinder and crank slowly to distribute the oil.
„ Slowly rotate the engine a few times with the starter rope
and install a new plug.
„ Slowly pull out the starter rope and stop at the
compression point.
„ Clean the entire mixer and engine compartment.
„ Clean the drum of all debris and foreign matter.
„ Clean all external parts of the mixer with a cloth.
„ Cover the mixer and place it a clean, dry area where it
will be protected from harsh elements.
to the
®