MULTIQUIP WM90SE Operation Manual page 28

6. Place the belt slip lever in the START/STOP
(disengaged) position. See Figure 23.
BELT SLIP
LEVER
Figure 23. Belt Slip Lever
(START/STOP Position)
7. Slowly pull the starter grip (Figure 24) until resistance
is felt, then pull briskly and smoothly to start the engine.
Gently return the starter grip to its original position.
STARTER GRIP
Figure 24. Starter Grip
PAGE 28 — WM90 SERIES PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #2 (10/30/19)
START-STOP
POSITION
(DOWN)
8. Once the engine has started, the emergency stop
switch should be tested for proper operation. Press
the emergency stop switch (Figure 25) and observe
that the engine has stopped.
EMERGENCY
STOP SWITCH
Figure 25. Emergency Stop Switch (STOP)
9. After verifying that the emergency stop switch is
working correctly, repeat the engine starting procedure
to begin mixing.
STARTING THE MIXER (ELECTRIC MOTOR)
1. Using an appropriately sized extension cord (Table 9),
connect one end of the extension cord to the plug on
the electric motor and connect the other end to the
power source. Make sure the motor is configured for
the proper operating voltage.
NOTICE
Equipment damage can result from low voltage.
Table 9. Recommended Extension Cord Sizes
50 ft.
HP VAC
(15.24 m)
3 230 No. 14
NOTICE
Extension cords must be rated Heavy Duty or Extra
Heavy Duty and must be a continuous length.
OPERATION
PUSH IN TO
STOP
75 ft. 100 ft. 200 ft.
(22.86 m) (30.48 m) (60.96 m)
No. 10 No. 10 No. 8