MULTIQUIP WM90SE Operation Manual page 25

Plaster and mortar mixers
Table of Contents

Advertisement

TIRES
Check for worn or defective tires (Figure 14). Replace any
defective or worn tires immediately.
CUT
DEFORMED
Figure 14. Tire Wear
PADDLE BLADE CHECK
Check for worn or defective paddle blades (Figure 15).
Make sure that all blades are adjusted properly. Refer to
the Paddle Blade Adjustment procedure in this manual
(Figure 17). Replace all defective or damaged blades
immediately.
WORN RUBBER
CRACKS
Figure 15. Worn Paddle Blade
WM90 SERIES PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #2 (10/30/19) — PAGE 25
BALDNESS
MISSING
RUBBER
CRACKS
MISSING
RUBBER
EMERGENCY STOP SWITCH
(GASOLINE ENGINE MODELS ONLY)
The engine emergency stop switch (Figure 16)
should be tested every time the engine is started. See
Starting the Mixer (Gasoline Engine) in the Operation
section for more information.
EMERGENCY
STOP SWITCH
Figure 16. Emergency Stop Switch
CAUTION
NEVER disable or disconnect the emergency stop
switch. It is provided for operator safety. Injury may result
if it is disabled, disconnected or improperly maintained.
INSPECTION
P U
T O
S H
S T
O P

Advertisement

Table of Contents
loading

This manual is also suitable for:

Whiteman seriesWm90peWm90sh8Wm90ph8

Table of Contents