MULTIQUIP WM90SE Operation Manual page 30

5. Lift the mixing bag compound onto the steel safety
grate over the bag cutter and let the contents fall into
the drum (Figure 29). Add more water if desired and
mix the compound to the desired consistency.
DUMPING
CAUTION
NEVER stand in front of or behind the
mixing drum while it is being placed in the
dump position. Stay clear of the mixing
drum while it is being positioned.
1. Pull down on the dump handle (Figure 30) to place the
drum in the dump position.
M U
D T
Figure 30. Dump Handle
WARNING
When rotating the
mixing drum from the
dump position to the
upright position, keep
hands clear of the
safety grate . The
possibility exists of
hands or fingers being
crushed.
2. Pull upward on the dump handle (Figure 30) to place
the drum in the upright position.
PAGE 30 — WM90 SERIES PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #2 (10/30/19)
DUMP
HANDLE
U B
STOPPING THE MIXER (GASOLINE ENGINE)
Normal Shutdown
1. Place the throttle lever in the IDLE (slow) position,
and let the engine idle for 3–5 minutes. See Figure 31.
THROTTLE
Figure 31. Throttle Lever (IDLE)
2. Turn the engine ON/OFF switch (Figure 32) to the
OFF position.
ENGINE SWITCH
Figure 32. Engine ON/OFF Switch (OFF)
3. Place the fuel valve lever (Figure 33) in the OFF
position.
FUEL VALVE
OFF
Figure 33. Fuel Valve Lever (OFF)
OPERATION
LEVER
IDLE
RUN
OFF
ON
LEVER
ON