Ride-on roller screed, kubota wg972-gl-e3 dual fuel, gas and propane engine (82 pages)
Summary of Contents for MULTIQUIP WM70SLF
Page 1
OPERATION MANUAL SERIES MODELS WM70SLF WM70PLF PLASTER AND MORTAR MIXER (MPOWER 177F-BH 9.0 HP GASOLINE ENGINE) Revision #0 (10/04/22) To find the latest revision of this publication or associated parts manual, visit our website at: www.multiquip.com THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Rotating parts hazards CAUTION Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE INJURY. NOTICE Addresses practices not related to personal injury. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 7...
Page 8
An explosion or fi re could result causing severe bodily harm or even death. DO NOT mix fl ammable or explosive substances. PAGE 8 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 9
NEVER tamper with the factory settings of the engine or engine governor. Damage to the engine or equipment can result if operating in speed ranges above the maximum allowable. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 9...
Page 10
Place chock blocks underneath the mixer wheels to DO NOT lift the machine to unnecessary heights. prevent rolling while parked. PAGE 10 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 11
Recyclers and manufacturers alike promote the process of recycling metal. Using a metal recycling center promotes energy cost savings. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 11...
Avoid sharp turns to prevent rolling. Figure 2. Drum Latch Pin ALWAYS make sure the fuel valve lever is in the OFF (Tow or Locked Position) position (gasoline models only). PAGE 12 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 13
3. As a minimum, use a 1/2-inch bolt and nyloc nut (grade 5) when securing either tow bar to the towing vehicle. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 13...
Bend hips and knees to squat down to the load, keep it close to your body, and straighten your legs to lift. PAGE 14 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
(ball, loop or pin). See Figure 8. Contact the MQ sales department for the desired tow bar. HLC-1 HPC-1 HBC-1 Figure 8. Optional Tow Bars WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 17...
Figure 11. Engine Oil Dipstick immediately. 3. Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 21...
5. Turn the engine switch (Figure 21) to the ON position. (Figure 18) in the CLOSED position. CHOKE LEVER ENGINE SWITCH OPEN CLOSE Figure 21. Engine ON/OFF Switch (ON) Figure 18. Choke Lever (CLOSED) PAGE 24 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 25
Gently return the starter grip to its original position. STARTER GRIP Figure 23. Starter Grip WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 25...
Page 26
(Figure 27). Add more water if desired and mix the compound to the desired consistency. PAGE 26 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 27
FUEL VALVE LEVER 2. Pull upward on the dump handle (Figure 28) to place the drum in the upright position. Figure 31. Fuel Valve Lever (OFF) WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 27...
Page 28
PUSH IN TO STOP Keep the drum, frame and wheels clean. Excess debris (buildup of materials) can lead to premature metal fatigue. Figure 32. Emergency Stop Switch (STOP) PAGE 28 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
(2) These items should be serviced by your service dealer, unless you have the proper tools and are mechanically proficient. Refer to the MPower Shop Manual for service procedures. (3) For commercial use, log hours of operation to determine proper maintenance intervals. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 29...
Page 30
3. Reinstall the drain bolt with sealing washer and tighten securely. 4. Replace the engine oil with the recommended oil type listed in Table 6. DO NOT overfill. See Table 4 for engine oil capacity. PAGE 30 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 31
4. If the spark arrester has breaks or holes or is otherwise damaged, replace it with a new one. 5. Reinstall the spark arrester and muffler protector in reverse order of disassembly. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 31...
GREASE FITTING AND CAP Figure 41. Grease Fittings (Countershaft) DRUM SUPPORT ENGINE BRACKET TOW END Figure 40. Grease Fittings (Dumping Mechanism) PAGE 32 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 33
0.001–0.010 inches of end play. Lock the nut at this position. Install the cotter pin and dust cap and tighten all hardware. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 33...
Page 34
7. DO NOT allow a buildup of materials to form on the blades or anywhere inside the drum. PAGE 34 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 35
DO NOT torque the wheel lug nuts all the way down. Torque each lug nut in 3 separate passes as defined in Table 9. NOTICE NEVER use a pneumatic air gun to tighten wheel lug nuts. WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 35...
Page 36
Clean all external parts of the mixer with a cloth. Cover the mixer and place in a clean, dry area where it will be protected from harsh elements. PAGE 36 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Air in fuel line? Bleed fuel line. Will not start, no power with key "ON". (if ON/OFF device not in ON position? Place ON/OFF device in ON posotion. applicable) PAGE 38 — WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22)
Page 39
Adjust choke valve to correct position. Carburetor defective, seal on carburetor Exhaust color is continuously "black". Replace carburetor or seal. broken? Poor carburetor adjustment, engine runs too Adjust carburetor. rich? WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 39...