Table of Contents
Advertisement
Changing the start and end time
Handset / Base unit
1
MMENUN#237
2
Continue from step 3 for handset or step
3 for base unit, "Turning do not disturb
mode on/off", page 48.
Selecting groups to bypass do not
disturb mode
Handset / Base unit
1
MMENUN#241
2
MbN: Select the desired group. a
MSELECTN
R "
" is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN: Select the group. a Press
MSELECTN again. "
3
MSAVEN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby's room, for example) will
automatically call the monitoring handset,
base unit, or the phone number stored when it
detects sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
R This feature should not be used as a
substitute for a medical or caregiver's
supervision. It is the caregiver's
responsibility to stay close enough to
handle any eventuality.
Note:
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored. If the base unit is
placed near the monitored handset, we
recommend turning off the base unit ringer
volume (page 46).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby's room).
" disappears.
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select the desired unit's number to
monitor with. a MSAVEN
R "Baby monitor" will be displayed.
R The registered unit's name/number is
Note:
R When this feature is on, another handset or
the base unit can hear the monitored
handset by making an intercom call.
To monitor from an outside line
If you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
This feature is only available for landline.
Programming
displayed.
49
Advertisement
Table of Contents
